燃煤氮氧化物排放控制技术研究进展及相关思考

简述了燃煤氮氧化物的产生、迁移、转化规律及其对环境造成的危害，综述了燃煤氮氧化物排放控制技术研究进展和存在的问题，提出了可供参考的相关建议及解决的方案途径。     

Methodological and Practical Considerations for Developing Multiproject Baselines for Electric Power and Cement Industry Projects in Central America

The Lawrence Berkeley National Laboratory (Berkeley Lab) and the Center for Sustainable Development in the Americas (CSDA) conducted technical studies and organized two training workshops to develop capacity in Central America for the evaluation of climate change projects. This paper describes the results of two baseline case studies conducted for these workshops, one for the power sector and one for the cement industry, that were devised to illustrate certain approaches to baseline setting. Multiproject baseline emission rates (BERs) for the main Guatemalan electricity grid were calculated from 2001 data. In recent years, the Guatemalan power sector has experienced rapid growth; thus, a sufficient number of new plants have been built to estimate viable BERs. We found that BERs for baseload plants offsetting additional baseload capacity ranged from 0.702 kgCO2/kWh (using a weighted average stringency) to 0.507 kgCO2/kWh (using a 10th percentile stringency), while the baseline for plants offsetting load-following capacity is lower at 0.567 kgCO2/kWh. For power displaced from existing load-following plants, the rate is higher, 0.735 kgCO2/kWh, as a result of the age of some plants used for meeting peak loads and the infrequency of their use. The approved consolidated methodology for the Clean Development Mechanism yields a single rate of 0.753 kgCO2/kWh. Due to the relatively small number of cement plants in the region and the regional nature of the cement market, all of Central America was chosen as the geographic boundary for setting cement industry BERs. Unfortunately, actual operations and output data were unobtainable for most of the plants in the region, and many data were estimated. Cement industry BERs ranged from 205 kgCO2 to 225 kgCO2 per metric ton of cement.     

Chance-constrained programming (CCP)abatement of SO_2 emission for acid deposition control in Liuzhou City

A deterministic linear programming model which optimizes the abatement of each SO2 emission source, is extended into a CCP form by introducing equations of probabilistic constrained through the incorporation of uncertainty in the source-receptor-specific transfer coefficients. Based on the calculation of SO2 and sulfate average residence time for Liuzhou City, a sulfur deposition model has been developed and the distribution of transfer coefficients have been found to be approximately log-normal. Sulfur removal minimization of the model shows that the abatement of emission sources in the city is more effective, while control cost optimization provides the lowest cost programmes for source abatement at each allowable deposition limit under varied environmental risk levels. Finally a practicable programme is recommended.     

ISAPEC中知识自动获取的设计与实现

剖析了利用人工神经网络实现大气污染总量控制规划智能决策支持系统（ＩＳＡＰＥＣ）中知识自动获取的必要性，论述了ＩＳＡＰＥＣ中知识的自动获取的设计与实现过程，并用一实例进行了验证。结果表明用人工神经网络实现知识的自动获取与知识的人工获取相比既具有更高的时间效率，又能保证更高的质量。     

北京市二个主要工业区汞污染及其来源的初步研究

为了调查北京市汞污染状况及其来源，选择二个主要工业区石景山区和朝阳区为研究对象．共采集表层土壤２６个，剖面样品４个，对照土壤样品４个，并且在冬季采集降雪样品和枯叶样品，分析汞含量．结果表明，燃煤烟尘排放的汞是北京市汞的主要来源，汽车尾气和化工厂泄漏可使局部汞含量增高，表层土壤中汞含量为００７—２７５ｍｇ／ｋｇ．土壤剖面中的汞含量在０—１００ｃｍ土层中均较高，其含量与土壤有机质和碳酸盐含量正相关．降雪中汞在０７—３７ｍｇ／Ｌ之间，明显高于背景值，其中大部分吸附在颗粒物上．枯叶中汞主要是从土壤吸收，并且有可能被雨水淋溶出来．     

汞在鲤鱼组织中的蓄积、排出与血流速度的关系

本试验在10±1℃、不喂食条件下测定鲤鱼在30天受汞毒期间鳃、脑和肝胰脏蓄积汞和尾鳍微血管血流速度及30天解毒期间排出汞和血流速度的变化。试验结果:受毒期间鳃中汞的蓄积量最多,解毒期间鳃中汞的排出速度最快;受毒期间血流速度随受毒时间的延长而减慢,又随试验浓度的增高而减慢,解毒期间血流速度随解毒时间的延长而加快;受毒期间高浓度试验组鱼鳃、脑和肝胰脏中汞的蓄积量与血流速度呈负相关,解毒期间鱼鳃中汞的排出量与血流速度呈正相关,汞的浓度与血流速度呈负相关。     

典型工业半焦的孔隙分形结构分析

工业半焦是一种具有复杂的微观孔隙拓扑结构的多孔物质.基于分形理论,引入分形维数对工业半焦不规则孔隙结构的粗糙、复杂程度进行了定量表征和描述.选取具有典型煤种和工艺代表性的工业半焦样品,用孔隙度分析仪对其孔隙结构特征进行了测量,并利用其测量数据进行了分形维数的分析计算.计算结果表明,工业半焦的孔隙结构符合分形特征,在样品颗粒尺寸为2.36～3.35mm的测量条件下,样品的分形维数在2.7982～2.9154之间,其可决系数在0.9157～0.9614之间;样品的分形维数与煤种和半焦热解工艺过程均有一定的关系.通过对工业半焦分形维数的计算分析,可以更加全面准确地了解其孔隙结构特征,以期为分析评价其吸附和活化潜力、制定恰当的活化工艺提供更加可靠的依据.     

锡工业砷和铅排放标准的初步研究

根据污染源现场调研结果,结合现有污染控制工艺所能达到的技术水平,建议污水排放标准中As浓度由现国家排放标准的0 5mg/L调整为0 1mg/L;Pb不变为1 0mg/L。大气污染物排放标准中As和Pb不变为1 0mg/L。大气污染物排放标准As和Pb的浓度限值分别是为0 5mg/m3和0 7mg/m3。     

贵阳市一居民区大气颗粒态汞的污染状况

2004年4、7、8、11、12月采用微型捕集管-冷原子荧光光谱法对贵阳市一个居民区大气中的痕量颗粒态总汞(TPM)进行了测定。结果表明:TPM日均浓度范围是0.149~4.853 ng.m-3,平均值是1.091 ng.m-3,显著高于背景参考值1~86 pg.m-3;TPM浓度采暖期大于非采暖期,夜间通常大于白昼;TPM与大气气态总汞(TGM)可能具有同源性;燃煤、垃圾焚烧以及周边工厂排放的含尘烟气可能是居民区大气颗粒态汞的主要人为来源。     

燃烧源中可吸入颗粒物排放特征及测量方法的研究进展

介绍了大气中可吸入颗粒物的来源分析，并对工业燃烧源和小型燃烧源的排放因子、排放测量方面的研究进行了总结。最后进一步探讨了燃烧源中可吸入颗粒物的未来研究重点和研究方向。